a brand of INWAVE AG

The RS-GGO10-O2P and RS-GGO10-O2G are reference oscillators with the same form factor as standard OCXO's (1"x1") with slightly increased height. A combination of novel circuits, special firmware and algorithms enable us to build this high performance unit in an ultra miniature size.
Available with (RS-GGO10-O2G) and without integrated GPS (RS-GGO10-O2P).
This type is usally called a GPS disciplined oscillator. Recommended for volume designs.


Phase noise (10MHz):

1PPS input (-O):
1PPS output (-OG):
Power supply:
Temperature range:


sine wave, +15dBm into 50?
-120 dBc/Hz typ. @ 10Hz offset
 -130 dBc/Hz typ. @ 100Hz offset
-142 dBc/Hz typ. @ 1kHz offset
-147 dBc/Hz typ. @ 10kHz offset
-152 dBc typ. noise floor
3.3V CMOS signal
5VDC +/-5% @ 270mA (620mA peak)
25.4x25.4x19mm (~1x1x0.75")
-30 to +75C (operating)
< 5x10E-11, typical <1x10E-11 (GPS locked)
+/- 50ppb (free running)
3.3V 2-wire bus with address 72 or 0x48

Phase Noise:

             Allan Variance


For the RS-GGO10-O2P a special firmware for free running applications with calibration mode is available. Please see the application note.

Download the RS-GGO10-O2x data sheet
Select the right reference application note
Comparison of RF-SUISSE GPS guided references

© 2013, INWAVE AG, Reute, Switzerland