a brand of INWAVE AG

The RS-GGO10-O and RS-GGO10-OG are reference oscillators with the same form factor as standard OCXO's (1"x1") with slightly increased height. A combination of novel circuits, special firmware and algorithms enable us to build this high performance unit in an ultra miniature size.
Available with (RS-GGO10-OG) and without integrated GPS (RS-GGO10-O).
This type is usally called a GPS disciplined oscillator.
A test board with (RS-TBGGO) and without GPGS receiver (RS-TBGGO-NG) is available.
Not recommended for new designs, use RS-GGO10-O2x instead

          

Frequency:
Output:
Phase noise (10MHz):



1PPS input (-O):
1PPS output (-OG):
Power supply:
Dimensions:
Temperature range:
Stability:

Interface:

10MHz
sine wave, +15dBm into 50?
-120 dBc/Hz typ. @ 10Hz offset
 -130 dBc/Hz typ. @ 100Hz offset
-142 dBc/Hz typ. @ 1kHz offset
-147 dBc/Hz typ. @ 10kHz offset
-152 dBc typ. noise floor
3.3V CMOS signal
3V CMOS
5VDC +/-5% @ 270mA (620mA peak)
25.4x25.4x19mm (~1x1x0.75")
-30 to +75C (operating)
< 5x10E-11, typical <1x10E-11 (GPS locked)
+/- 50ppb (free running)
3.3V 2-wire bus with address 72 or 0x48

          

 

Phase Noise:

             Allan Variance

        

Download the RS-GGO10-O data sheet
Download the RS-GGO10-OG data sheet
Download the RS-TBGGO datasheet (test board)
Select the right reference application note
Comparison of RF-SUISSE GPS guided references

© 2013, INWAVE AG, Reute, Switzerland